Electronics Incorporated - The Shot Peener - Shot Peening Library
Title: A 3-D Numerical Study of Shot Peening Process Using Multiple Shot Impacts
Author: GH Majzoobi , R Azizi
Source: Conf Proc: ICSP-9 (pg 88-93)
Publication year 2005
Document number: 2005056
Number of pages: 6
Abstract:
ABSTRACT
LS-DYNA code was employed and validated for the numerical simulations in this work. The modeling of shot peening process was accomplished by simulation of multiple shot
impacts on a target plate at different velocities and angles. From the simulations, the compressive residual stress profiles were obtained and the effects of shot angle,
velocity and multicipility were investigated. The results showed that, residual stress distribution was highly dependent on these parameters. A uniform state of stress was
achieved at a particular number of shots. Impact velocity significantly influences the residual stress profile. The increase of velocity improves the residual stress
distribution up to a particular point. Further increase in the velocity may reduce the maximum residual stress. A close agreement between the numerical residual stress
profiles obtained in this work was achieved with the experimental profiles reported by Torres and Voorwald. The deviation of impact angle from 90° must be compensated by the
increase of shot velocity.
This paper not available. Book ICSP-9 is available at http://www.iitt.com OR Electronics Inc +1-574-256-5001
www.shotpeener.com
This page last revised: 04/24/2008