Electronics Incorporated - The Shot Peener - Shot Peening Library
Title: Fatigue Strength of the Steel After the Percussive Burnishing Process
Author: D. Stadnicka
Source: Conf Proc: ICSP-9 (pg 280-285)
Publication year 2005
Document number: 2005098
Number of pages: 6
Abstract:
ABSTRACT
The percussive burnishing method, which can be used for treating the outer cylindrical surface of a shaft, was worked out in the Department of Manufacturing Process and
Production Organization in the Technical University of Rzeszow. This method gives the possibility of the wide regulation within the range of the impact energy, impact traces
arrangement on the workpiece surface and shapes of the single traces. We can use this method for processing both the soft and the hard materials. After the treatment we
obtain the specific surface stereometry, which is characterized by the regular patterns. Depending on the kind of patterns, intensity of the treatment and other treatment
parameters various changes in the surface layer are caused. With the use of this method we can increase fatigue strength of the steel component in order to know, what
influence the percussive burnishing process has on the treated elements, studies using 42CrMo4 steel were done and their results are presented in this paper.
This paper not available. Book ICSP-9 is available at http://www.iitt.com OR Electronics Inc +1-574-256-5001
www.shotpeener.com
This page last revised: 04/24/2008