Electronics Incorporated - The Shot Peener - Shot Peening Library
Title: Advances in Shot Peening of Silicon Nitride Ceramics
Author: W. Pfeiffer and T. Frey
Source: Conf Proc: ICSP-9 (pg 326-331)
Publication year 2005
Document number: 2005105
Number of pages: 6
Abstract:
ABSTRACT
Shot peening is a common procedure to improve the static and cyclic strength of metal components. It is based on a multiple localized plastic deformation of near-surface
regions. Ceramics show at room temperature the typical brittle material behavior of failure before deformation. Thus, strengthening of ceramics due to deformation induced
compressive residual stresses has been thought to be not possible. Recent investigations showed, however, that also in brittle materials like ceramics high compressive
stresses can be introduced near the surface.
This presentation compiles the status of the novel shot peening technique applied to silicon nitride ceramics. The results show that high compressive residual stresses in
the GPa-range can be introduced in silicon nitride which may boost the static and cyclic load capacity of the near surface layer by a factor of up to 5. In addition, the
fracture toughness of the near-surface region is dramatically improved.
This paper not available. Book ICSP-9 is available at http://www.iitt.com OR Electronics Inc +1-574-256-5001
www.shotpeener.com
This page last revised: 04/24/2008