Electronics Incorporated - The Shot Peener - Shot Peening Library
Title: Eigenstrain Generated by Shot Peening in Udimet 720LI Inferred By Means of Finite Element and Analytical Models
Author: M. Satraki, A. Evans, A. King, G. Bruno, P. Wither
Source: Conf Proc: ICSP-9 (pg 442-447)
Publication year 2005
Document number: 2005122
Number of pages: 6
Abstract:
ABSTRACT
The residual stress in shot peened Udimet 720Li was determined by laboratory X-ray diffraction measurements. Depth profiles were obtained by electrochemical layer removal
and a tensile peak was observed sub surface. A correction for layer removal was applied and the corrected data has been used to calculate the profile of the eigenstrain
necessary to generate such a residual stress profile. Calculations were made applying two methods: 1) A Finite Element Model (FEM) using a thermally driven expansion to
simulate the eigenstrain, 2) A simple analytical model. The latter took into account strain hardening, as measured in fatigue tests, and stress balance. Using the
eigenstrain profile, the geometrically necessary cold work stored in the component was calculated. Results show a very good agreement between the two different models. The
analytical method predicts a compressive misfit, while this was explicitly discarded in the FEM model. The calculated cold work is essentially the same for both models, but
shows different behaviour from the peak integral width.
Download full text pdf file
www.shotpeener.com
This page last revised: 09/28/2008