Previous Thread
Next Thread
Print Thread
Joined: Apr 1999
Posts: 341
Likes: 1
J
Member
OP Offline
Member
J
Joined: Apr 1999
Posts: 341
Likes: 1
Jack,
Does Arc height always accurately indicate compressive residual stress levels at a specific depth in the Almen strip. If yes, then can we correlate that to residual compressive stress in our parts consistently? What are the variables that would make that a poor measure for process control?
Name and Company Withheld

Joined: Apr 1999
Posts: 341
Likes: 1
J
Member
OP Offline
Member
J
Joined: Apr 1999
Posts: 341
Likes: 1
The answer is a "qualified" yes, the Almen strip is curving as a result of the compressive stresses induced and IF the key process parameters are unchanged then yes, the stress in your part will be consistent. However, media size and hardness may influence the (compressive) residual stress at a given intensity. It is therefore very important that you maintain the media quality and shot projection (velocity and flow rate).

Jack

Joined: Apr 2007
Posts: 4
S
Member
Offline
Member
S
Joined: Apr 2007
Posts: 4
But,what is the correlation between the Almen arc height and the level of residual stress. is there a simple formula or algorithm for the relation between the two?

Also, can we have a similar relationship between increase of hardness due to'cold work' by peening and the residual stress level?

Shankar
India

Joined: Apr 1999
Posts: 341
Likes: 1
J
Member
OP Offline
Member
J
Joined: Apr 1999
Posts: 341
Likes: 1
A simple chart is shown at our web site "Learning on Line":

http://www.shotpeener.com/learning/multi%20depth%20vs%20intensity.pdf


Link Copied to Clipboard
Sponsored by Electronics Inc. © 2024 Electronics Inc. All Rights Reserved.
Powered by UBB.threads™ PHP Forum Software 7.7.5