Grease and oil in shot peening process - 05/25/09 02:38 PM
Hello!
I am new here at shotpeener.com/forum.
I have an question about grease and oil in an wheelblaster.
We shotpeen gears for a gearbox mounted in trucks.
We clean our gears today after honing. The cleaner leave a little little amount of oil on the gears fo corrosive protection.
Now we want to shotpeen the gears after that cleaning process.
I woul like to know if there is any theory about how much oil the income producs can have before it is shotpeened?
We use an wheelblaster from Wheelabrator Shlick with a 0,9mm media (cut wire).
Best regards
Johan Pajuluoma
Sweden
I am new here at shotpeener.com/forum.
I have an question about grease and oil in an wheelblaster.
We shotpeen gears for a gearbox mounted in trucks.
We clean our gears today after honing. The cleaner leave a little little amount of oil on the gears fo corrosive protection.
Now we want to shotpeen the gears after that cleaning process.
I woul like to know if there is any theory about how much oil the income producs can have before it is shotpeened?
We use an wheelblaster from Wheelabrator Shlick with a 0,9mm media (cut wire).
Best regards
Johan Pajuluoma
Sweden