Previous Thread
Next Thread
Print Thread
#1300 11/21/17 06:25 PM
Joined: Nov 2013
Posts: 55
T
tec Offline OP
Member
OP Offline
Member
T
Joined: Nov 2013
Posts: 55
Hi,

We have a necessity to speed up our production process due to increased demand.

What advice can be given as to where to start.

Generally we are peening long round parts with a hole through them. Using a wheel for external and lance for internal.

Thanks in advance for your assistance.

Joined: Apr 1999
Posts: 341
Likes: 1
J
Member
Offline
Member
J
Joined: Apr 1999
Posts: 341
Likes: 1
1. For wheel blast increase media flow rate (same RPM)
2. For Air blast increase media flow rate (may have to increase air pressure to maintain intensity
3. For Air blast use larger size lance and higher media flow rate
4. Buy additional new equipment and double your productivity..

Joined: Nov 2013
Posts: 55
T
tec Offline OP
Member
OP Offline
Member
T
Joined: Nov 2013
Posts: 55
Many thanks, wish we could go for number 4 that would be the best solution.

Joined: May 1999
Posts: 197
Member
Online Content
Member
Joined: May 1999
Posts: 197
If possible, use a smaller diameter peening media.

Joined: Apr 1999
Posts: 341
Likes: 1
J
Member
Offline
Member
J
Joined: Apr 1999
Posts: 341
Likes: 1
And if you use smaller diameter peening media be sure to adjust the wheel speed (RPM) or the nozzle air pressure (PSI) to get you back to the correct intensity.

Joined: Jan 2018
Posts: 2
I
Member
Offline
Member
I
Joined: Jan 2018
Posts: 2
Originally Posted By tec
Many thanks, wish we could go for number 4 that would be the best solution.


Check out my signature and order new machines ;-), that's the best solution. You have also calculator on our websiste.


Link Copied to Clipboard
Sponsored by Electronics Inc. © 2024 Electronics Inc. All Rights Reserved.
Powered by UBB.threads™ PHP Forum Software 7.7.5