Previous Thread
Next Thread
Print Thread
Joined: Aug 2016
Posts: 20
D
donhan Offline OP
Member
OP Offline
Member
D
Joined: Aug 2016
Posts: 20
I am Nhan Do from Pioneer Drilling in Viet Nam.

My shot peening machine is currently using Magna Valve 578-24 for cast steel shot.

We would like to change material of shot to stainless steel shot. Which valve model we have to buy to use stainless steel shot.

Please advise us on this.

Thank you.
Best regards,

Joined: Dec 2016
Posts: 2
J
Member
Offline
Member
J
Joined: Dec 2016
Posts: 2
Hello Nhan, I apologize for the late reply. Can you tell me what type of stainless steel shot you would like to use?

The only stainless shot that the Magnavalves (and not all models) will only work with is stainless conditioned cut wire.

Please note that you can send product inquiries directly to EI at: [email protected]

Joined: Aug 2016
Posts: 20
D
donhan Offline OP
Member
OP Offline
Member
D
Joined: Aug 2016
Posts: 20
Hi Joenat,

Thanks for your reply.

I would like to use stainless ball shot, not stainless cut wire shot.

My customer required on drawing S550 (Non mag type) so i think about stainless steel ball shot instead of cast steel shot.

Joined: Dec 2016
Posts: 2
J
Member
Offline
Member
J
Joined: Dec 2016
Posts: 2
Hello Nhan,

Unfortunately, we do not have model that will work with
stainless ball shot. You will have to find a different
method of controlling that media.


Link Copied to Clipboard
Sponsored by Electronics Inc. © 2024 Electronics Inc. All Rights Reserved.
Powered by UBB.threads™ PHP Forum Software 7.7.5