■ How is %Intensity vs. Corner/Shot Radius Ratio Chart created?
■ Under what circumstances?
■ How is it possible to relate intensity and corner radius on a part?
■ Why is "%" used with intensity?
■ If I want to perform the same test for confirmation, how should I perform it?
Thanks
N. Hakan Karaaslan
Metalworking Engineer
GE Aviation
T +90 262 677 6044
E nevzat.karaaslan@ge.com
TUBITAK-MAM Teknoloji Serbest Bölgesi
41470, Gebze, Kocaeli, Turkey
GE Marmara Technology Center Muhendislik Hizmetleri Limited Sirketi
| 
