Active Topics | Active Posts | Unanswered Posts Past 24 hours | Past 48 hours | Past 7 days
Forum   Subject
Shot Peening Process, Intensity, Coverage
Jump to new posts What Intensity to Use? by Rich @ Yesterday at 05:40 PM

Ok, I know how to do the saturation curve to determine what the intensity is per whatever settings.... However what baffles me, is that up till now, the intensity to use per whatever part is being shot seem to be a feel good decision not based on an
Shot Peening Process, Intensity, Coverage
Jump to new posts Re: Coverage Inspection by Rich @ 01/27/20 01:43 PM

Thanks
Media, Shot, Beads, etc.
Jump to new posts Re: Fatigue testing results by Jack Champaigne @ 01/23/20 03:21 PM

"The average fatigue failure was about 25% higher in the samples peened with cast steel shot". Rephrasing the report can give different interpretation. "The steel provided a 25% increase in fatigue life" seems like the proper way

Sponsored by Electronics Inc. © 2020 Electronics Inc. All Rights Reserved.