Specifications | Q & A Forum

You are not logged in. [Log In] Home » Forums » General Discussion » Specifications

Page 1 of 4

Forum Options

Subject / Poster	Replies	Views	Posted
Special dust collector when peening titanium? by Jack Champaigne	0	3176	02/27/18 09:55 AM by Jack Champaigne
Process Technique Card by Rich	0	208	03/20/20 11:24 AM by Rich
Typical Nonconformances in a NADCAP Audit by Rich	3	479	03/11/20 11:20 AM by Walter
Aerospace Qualification by Rich	1	761	07/29/19 03:15 PM by Walter
Edge Break Prior to peening AMS2430 / ARP7488 by Walter	2	893	06/25/20 10:52 AM by Walter
Rejectable parts by shotgirl	1	1308	09/06/18 03:55 PM by Charlie
Users of AMS-S-13165 by Jack Champaigne	0	1383	01/12/05 03:47 PM by Jack Champaigne
Embrittlement Relief Temperature by cparsons	0	1429	06/17/99 10:47 AM by cparsons
suggested revisions to AMS-S-13165 by Jack Champaigne	0	1449	01/11/05 05:02 PM by Jack Champaigne
AISI 301 grade stainless to AMS 2431/4 by tec	0	1465	06/30/15 07:07 PM by tec
Annual testing parameters for peening machines by Sue Hoke	0	1490	01/02/07 11:07 AM by Sue Hoke
The flow rate meassurement AMS 2430? by Edgar Ortega	2	1496	03/16/20 10:11 AM by Jack Champaigne
conveyer speed by Sue Hoke	0	1637	01/16/07 01:21 PM by Sue Hoke
peening specification for chain link by vishal	0	1649	06/04/07 01:41 AM by vishal
J442 May 2006 published by Jack Champaigne	0	1661	05/26/06 08:58 AM by Jack Champaigne
AMS 2430 Cast Steel Shot Conditioning by scottbonar	0	1813	03/26/04 08:12 AM by scottbonar
AMS2430 Revision N by Walter	0	1818	07/17/08 11:47 AM by Walter
AMS-2431/3 , /8 by Walter	0	1825	09/07/04 10:06 AM by Walter
AMS 2430 Rev U by tec	0	1852	08/04/16 03:24 AM by tec
SAE AMS 2432B Approval by webmaster	0	1929	04/28/99 11:29 AM by webmaster
AMS2430 P by Walter	0	1939	03/23/09 11:49 AM by Walter

Page 1 of 4

Moderator: Andy Levers, Dave Barkley, Jack Champaigne, Jeff Derda, John Cammett, Kumar Balan, Socrates, Walter