Topic Options
#1439 - 10/01/19 09:15 AM Looking to start shot peening, advice needed
mt92 Offline

Registered: 09/25/19
Posts: 1
Loc: Il
I am the process engineer at a machine shop specializing in shaft work. We have some new parts that require one area to be shot peened.
The shaft are around 3.5" diameter and the spec called out is MIL-S-13165 110H intensity 10-14A.
I am looking for a used machine.

We have a steep learning curve ahead and any help to point us in the correct direction would be appreciated.
Mike Tinkham

#1441 - 11/29/19 10:06 PM Re: Looking to start shot peening, advice needed [Re: mt92]
Walter Offline

Registered: 05/03/99
Posts: 158
Loc: East Hartford, CT, USA
10-14A with ASH-110 (otherwise known as S-110 Hard) is not a good idea. 10A is about as high as you should attempt with 110.
Also, MIL-S-13165 was cancelled many years ago and superseded by AMS 2430.


Sponsored by Electronics Inc. © 2020 Electronics Inc. All Rights Reserved.