Previous Thread
Next Thread
Print Thread
Joined: Apr 2022
Posts: 1
E
Member
OP Offline
Member
E
Joined: Apr 2022
Posts: 1
I have two shot peen machines that use SAE S110 Cast Steel Shot. Recently reviewed the sieves on both of the machine's classifiers and they were in need of replacement.

Can someone provide guidance on what the upper and lower sieve should be on the machine's classifier for this size shot?

Also is there a publication that I can cross reference the sieves to be used for shot peen machine classifiers?

Thank you.


Eric W. Stratton
Subject Matter Expert- Chemical Processes and Coatings
Repair Process Support & Technology
Pratt & Whitney Aftermarket & Sustainment Engineering (ASE)
O: 972.343.2713 M: 682-557-9914
Joined: Apr 1999
Posts: 332
J
Member
Offline
Member
J
Joined: Apr 1999
Posts: 332
Check web site at Progressive Surface for screen information.

https://www.progressivesurface.com/downloads/tables/SCREENS.pdf


Moderated by  Socrates 

Link Copied to Clipboard
Sponsored by Electronics Inc. © 2022 Electronics Inc. All Rights Reserved.
Powered by UBB.threads™ PHP Forum Software 7.7.5