Home Forums General Discussion Shot Peening Process, Intensity, Coverage peening coverage or overpeening

Print Thread

Re: peening coverage or overpeening #145 02/06/07 10:37 PM
Joined: May 1999 Posts: 199 East Hartford, CT, USA Walter Member
Walter Member Joined: May 1999 Posts: 199 East Hartford, CT, USA	Over peening is a condition that can be caused be either peening above the specified intensity range or by excessive coverage, usually more than 200%. Over peening is easily identifiable by rolled edges or bulging of material. A simple definition would be: Over peening is a condition were the part exceeds the drawing limitations on intensity and or the part exhibits material edge roll and or bulging.

Entire Thread
Subject	Posted By	Posted
peening coverage or overpeening	54lg	02/06/07 06:41 AM
Re: peening coverage or overpeening	Walter	02/06/07 10:37 PM

Link Copied to Clipboard