Home Forums General Discussion Shot Peening Process, Intensity, Coverage Peening at very high intensity

Print Thread

Peening at very high intensity #153 03/21/05 01:00 PM
Joined: Jan 2005 Posts: 35 Mishawaka Indiana, USA Dr Peener OP Administrator
OP Dr Peener Administrator Joined: Jan 2005 Posts: 35 Mishawaka Indiana, USA	We are using EN 24 Steel for axle shaft. We are doing shot peening on these axle shafts. Specified Arc intensity is 015 " to 0.020 " ( Almen strip A scale) But actual measured Arc intensity is 0.060 ". What will be the effect of this overpeening? Jack Champaigne (Dr. Peener) Editor The Shot Peener

Entire Thread
Subject	Posted By	Posted
Peening at very high intensity	Dr Peener	03/21/05 01:00 PM
Re: Peening at very high intensity	Dr Peener	03/21/05 01:09 PM
Re: Peening at very high intensity	903dykeswa	06/30/11 05:38 PM
Re: Peening at very high intensity	Socrates	06/30/11 06:45 PM

Link Copied to Clipboard