Home Forums General Discussion Equipment, Machines, Accessories Almen Gage Zero Block Flattness (SAE J442)

Print Thread

Re: Almen Gage Zero Block Flattness (SAE J442) #318 03/07/09 12:25 AM
Joined: Apr 1999 Posts: 341 Likes: 1 Mishawaka, IN, USA J Jack Champaigne Member
Jack Champaigne Member J Joined: Apr 1999 Posts: 341 Likes: 1 Mishawaka, IN, USA	Yes, the flat side will be measured and its value must be equal or less than the required flatness of 0.005mm. The curved side is not measured. It is for reference only. Do not try to measure the curvature of the curved side.

Entire Thread
Subject	Posted By	Posted
Almen Gage Zero Block Flattness (SAE J442)	j-mitsunaga	03/04/09 11:43 PM
Re: Almen Gage Zero Block Flattness (SAE J442)	Jack Champaigne	03/05/09 01:18 PM
Re: Almen Gage Zero Block Flattness (SAE J442)	j-mitsunaga	03/06/09 01:47 AM
Re: Almen Gage Zero Block Flattness (SAE J442)	Jack Champaigne	03/06/09 09:24 PM
Re: Almen Gage Zero Block Flattness (SAE J442)	j-mitsunaga	03/06/09 11:32 PM
Re: Almen Gage Zero Block Flattness (SAE J442)	Jack Champaigne	03/07/09 12:25 AM
Re: Almen Gage Zero Block Flattness (SAE J442)	j-mitsunaga	12/21/09 02:31 AM
Re: Almen Gage Zero Block Flattness (SAE J442)	Jack Champaigne	12/21/09 02:08 PM

Link Copied to Clipboard