Home Forums General Discussion Specifications AMS 2432 frequency of intensity checks

Dear Dr. Peener

We have a computer controlled shot peening machine and we have been taking intensity verifications at the beginning and end of each lot of parts or every 8 hours - whichever is the least amount of time. However when reading AMS 2432 page 11, 4.3.2.1 it sounds as if we should be running strips before and after production runs and at least every 4 hours of production. Is this correct or is there something I am overlooking?

I understand there is a revision in the works for AMS 2432, is this correct information?

Thank you in advance for your assistance.

Sue