Jack.I took your seminar in Scottsdale Az. Now I am trying to convice my fellow employees and engineering, that you do not figure your parts run time off of your saturation curve. The way we develope parts is take a test part with almen blocks on it and find the 100% and then check 200%. Making sure it only moves 10% from 100% to 200%. Then we run our saturation points every two min. I need to find some documentation to show use how to do developments properly. Your the man. So I'm really counting on you.
[This message has been edited by jChampaigne (edited December 06, 2003).]
